|
| FEATURES |
Impeller:
Cast iron, two vane semi open, non-clog with pump out vanes for mechanical seal
protection. Balanced for smooth operation. Silicon bronze impeller available as an option.
- Casing: Heavy duty cast iron, volute type for maximum efficiency.
3" flange conforms to 125 PSI ANSI standard. Adaptable for A10-30 slide rail systems.
- Dual Mechanical Seal: Ceramic vs. carbon sealing faces, stainless steel
metal parts, BUNA-N elastomers. Upper and lower shaft seals are positioned independently
and are separated by an oil-filled chamber. Optional SILICON CARBIDE OR TUNGSTEN CARBIDE
faced lower seals available.
- Shaft: 300 series stainless steel keyed design.
- Motor: Fully submerged in oil-filled chamber. High grade turbine oil
surrounds motor for more efficient heat dissipation, permanent lubrication of bearings and
mechanical seal for complete protection against outside environment.
- Designed for Continuous Operation: Pump ratings are within the motor
manufacturer’s recommended working limits and can be operated continuously without
damage.
- Bearings: Upper and lower heavy duty ball bearings construction for
precision positioning of parts and to carry thrust loads.
- Power Cable: Severe duty rated, oil and water resistant. Epoxy seal on
motor and provides secondary moisture barrier in case of outer jacket damage and to
prevent oil wicking.
- 0-ring: Assures positive sealing against contaminants and oil leakage.
|
APPLICATIONS
Used in a variety of residential, commercial and industrial applications
such as: |
- Sewage Systems
- Flood and pollution control
- Dewatering
- Farms
- Hospitals
- Trailer courts
- Motels
|
SPECIFICATIONS
Pump |
Solids
handling capability: 3" maximum.
Discharge size: 3" flanged
Capabilities: up to 470 GPM
Total heads: up to 65 feet TDH.
Mechanical seals: carbon rotary/ceramic stationary, 300 series stainless
steel metal parts, BUNA-N elastomers..
Temperature: 104O F (40OC) continuous 140O
F (60OC) intermittent.
Fasteners: 300 series stainless steel.
Capable of running dry without damage to components. |
| Motor: |
Single
Phase: 1-1/2 - 5 HP, 200V, 230V, 60 Hz, 1750 RPM. Built-in overload with
automatic reset on 1 1/2 - 2 HP. Pilot duty thermal sensors 3 and 5HP. Over temperature
protection must be connected in control panel. Capacitors must be provided in 3 and 5 HP
control panel. CP-2 capacitor pak must be used to validate warranty if not using Goulds
control panel. Permanent split capacitor type.
Three Phase: 1 1/2 - 5 HP, 200/230/460V, 60 Hz, 1750 RPM. Overload
protection must be provided in starter unit.
Class B insulation.
Shaft: 300 series stainless steel, keyed design.
Bearings: ball bearings upper and lower.
Power cord: 20 foot standard.
Single phase - 14/3 STO, 10/3 STW 3 and 5 HP Three Phase - 14/4 STO, 10/4
StW 5 HP, 230V. Optional lengths available.
On CSA listed Models, 20 foot length SJTW and STW are standard. |
